Namco Bandai Games Skis 90500041 Manual do Utilizador

IT IS THE RESPONSIBILITY OF THE OPERATOR TO MAINTAIN CUSTOMERSAFETYAT ALL TIMES, AND IT IS IMPERATIVE THAT THE DETAILS SET OUTINTHIS MANUAL ARE FOLLOW

Page3-3 Test Mode1. Open the coin door and slide the test switch “ON”. The menu screen will bedisplayed on the monitor.2. Select the test required by

Page3-3-1 Coin Options1. Select item (1) “COINOPTIONS” on themenu screen to setthe game cost andrelated settings.2. Press ‘Select L/R’ toselect the re

Page3-3-2 Game Options1. Select item (2) “GAME OPTIONS” on the menu screen to set thegame options and related settings.2. Press ‘Select L/R’ to select

PageI/O TESTDIP 4 12345678 ...(a)SWITCH TEST ...(b)MOTOR TEST ...(c)STEP AD

Page3-3-3-1 Switch Test1. Select Switch Test from the ‘I/O Test’ menu. The following screen willappear on the monitor.Note:- On entering Switch Test t

Page3-3-3-2 Motor Test1. Select Motor Test from the ‘I/O Test’ menu. The following screen will ap-pear on the monitor.MOTOR TESTNOW MOTOR STATE : LOCK

Page3-3-4 Sound Test1. Select item (4) “Sound Test” on the menu screen to test the soundand speakers.2. The following screen will appear on the monito

Page3-3-5 Monitor Test1. Select item (5) “Monitor Test” on the menu screen to set up and adjust themonitor.2. On entering monitor test, the screen wil

Page3-3-7 Others1. Select item (7) “Others” on the menu screen.2. On entering ‘Others’ the following screen will appear on the monitor.OTHERS(DEFAULT

PageMOTOR ERROR 1PLEASE STEP ADJUST4 INITIALIZATIONInitialization must be performed before operation and after replacing thegame PC board, Rom or Step

SAFETY WARNINGIn order to use this machine safely, be sure to read this Installation andCommissioning manual and the Operators Manual carefully before

Page4-2 Adjustment Method (b)1. Slide the test switch ON.2. Turn the power OFF and then back ON again.3. Select “I/’O TEST” and press the decision but

Pagee. If after the steps have been freed, they donot re-lock, as an emergency measure,Motor Error 3 screen is displayed. Thisallows the step-lock mec

Page2. INSTALLATIONNotes on InstallationDANGER: NEVER turn the power to the machine ON until installation hasbeen completed.DANGER: In order to avoid

PageThis machine is designed for indoor use only. Do Not install the machine in anyof the following places.3

PageSafety Mechanisms and ControlsFor safety, this machine is equipped with a locking mechanism for securing thesteps when the machine is not being pl

Page2-1 Fitting the Header AssemblyThe Header Assembly has a forward centre of gravity, so it is importantthat at least two people are used to fit or

Page 62-2 Connecting the Ski Assy to the Monitor Cabinet.1. Connect the connectors between the Ski Assembly and Monitor Cabinet.2. Push the Ski Assemb

Page 7NOTE:-When the machine is fully assembled and in its final position, lower the 10 leveladjusters, (4 on the monitor cabinet and 6 on the ski ass

Page3. ADJUSTMENTS3-1 Turning on the PowerAfter the machine has been installed, turn ON the power. The power switchis located on the rear of the monit